To use TunnelBear VPN in Windows,follow these organized steps:

1. Download and Install TunnelBear VPN:

   • Visit the official TunnelBear VPN website and download the latest version.
   • Save the installation directory to your computer.

2. Log In:

   • Open "C:\Windows\Start Menu" or "Run" in the Command Prompt.
   • Change the prompt to "C:\Users\Username\Password\Start."
   • Type your TunnelBear VPN credentials and press Enter.

3. Configure Your Account:

   • Switch to the Settings panel by clicking the gear icon in the top-right corner.
   • Select "Sign In" and click "Refresh" to verify your credentials.

4. Enable Multi-Device Access:

   In the Settings, click the "Multi-Device" option and then "Yes" to save your settings.

5. Configure Devices:

   • Open the Settings panel and click on "Device" to see available devices.
   • Click on each device to make it available (note: mobile devices may require special handling).

6. Connect to TunnelBear:

   • Click "Connect" to connect to TunnelBear.
   • Wait a few seconds for the connection to establish.

7. Set Privacy Mode:

   Navigate to Settings, select Privacy, and click "Yes."

8. Test Connection:

   Click "Test" or use the menu icon to verify connection success.

9. Check Wi-Fi and Performance:

   • Ensure public Wi-Fi is enabled and that no unnecessary services are blocked.
   • Adjust settings to optimize performance.

10. Use the VPN:

    • Switch to the Settings panel and select a device.
    • Download your preferred browser and use it to access internet.

11. Exit Settings:

    Close the Settings panel and reboot your computer.

By following these steps, you should be able to successfully use TunnelBear VPN on your devices and connect to public Wi-Fi seamlessly.